MKHFP ETCR9330B - 9999A 5 inches (128mm)

Function Meter Dimension Detector:210mm×246mm×45mm; Receiver:78mm×165mm×42mm Connecticut Size 5 inches (128mm) Insulation Rod Size 45 mm, Contraction state: 850 mm; Stretched state: 3600 mm. Insulation Rod Voltage Level 110KV Sampling Rate 2 times / second Measuring range 0.0 0A~9999A(50/60Hz automatic) Resolution 0.01A changeover 0.00A~9999A automatic shift Test Accuracy ±2%±5dgt (The wire is near the center of the bottom end of the U-type clamp,23±2) Position Error The measured conductor should be located as close as possible to the center of the bottom end of the U-type clamp. Data Storage 99 groups, in storage process "Mem" symbol display, "FULL" symbol flash display indicate storage is full Voltage Line Bare wire test below 60kV (Operate with insulation rod, the telescopic insulation rod is completely opened) Data Hold In general test mode, press KEEP key to hold data, "KEEP" symbol display. Press KEEP Key once again to cancel this function Access to data "MR" symbol display, it can look over all the stored data Overflow Display Exceed measurement range overflow function: "OL A" symbol display No Signal Indication When the receiver has not received transmit signal, dynamic display "no- -"symbol. Automatic Shutdown 15 minutes after boot up, the meter shuts down automatically without any operation, to reduce battery consumption Battery Voltage When battery voltage is lower than 4.8V, low battery voltage symbol "" display and remind to replace battery. Weight: Detector:300g(with Battery), Receiver:280g(with Battery), Total weight: : 2300g (include insulation rod and battery) Working temperature -10 ~ 40; Below 80%Rh Interference Should try to avoid 315MHz, 433MHz same-frequency