Ycauty i04xljrudy-13 - DC12V

1. [ULTRA SAFE BATTERY TESTING] Continuous testing with battery power without damage, reverse polarity protection, and over-voltage protection ensure safety for users.
2. [ACCURATE BATTERY ANALYSIS] Test and analyze battery load system to indicate battery condition including life percentage, CCA, voltage, and with precise results.
3. [WIDE COMPATIBILITY] Compatible with most 12V battery types, including Flood, AGM, Gel, and Deep Cycle batteries, offering reliable operation for various sizes.
4. [INTUITIVE DESIGN] Large LED screen, heavy-duty clamp, and beep reminder function for durability and reliability during testing.
5. [EASY TO USE] Simple power-on process, clear instructions for inputting values, and quick testing mode in just 10 seconds for effortless operation.

Spec

• Item Type: Battery Tester
• Material: ABS
• Color: As shown in the picture
• Host Size: Approx. 13x6.2x2.8cm / 5.1x2.4x1.1in
• Weight: Approx.261g/9.2oz
• Input Voltage: DC12V
• Test Items: Voltage, , CCA, battery condition
• Applicable Object: 12V battery

Wide Operating Range

• CCA: 100-1700
• DIN: 100-1000
• IEC: 100-1000
• En: 100-1700

Battery Life Percentage

• 80% - 100% Good Condition
• 60% - 80% OK, Not Bad
• 40% - 60% Need Attention
• 0% - 40% Bad, Need to Exchange Required
• How to Use

1. Power of the analyzer is supplied by the vehicle battery.For testing,the clinchers of the analyzer should be clinched correctly on the battery during is testing.(Red clincher means positive terminal and black clincher means negative terminal which should be clinched correspondingly on the terminals of the battery.
2. Turn on and input

• a. Press the power button for 1 second
• b. The screen gets lightening and Bee alarm will emit a "B"sound.
• The screen shows moving digits, all test indexes and low battery caution index.

c. Press "OK"it gets into the step of CCA (Cold Cranking Ampere) value input d. The third digit on the right of the four digits number index blinks, it means the indication digit is changeable by UP(increasing) or DOWN(decreasing) function button. Press the UP(increasing) or DOWN(decreasing) function button until the correct digit shows and move to digit place for value-input by pressing "SEL".

e. The units digit on the right if the four-digits number carries each time 5 units in adding, the other digits carry once an unit in adding.

f. After input steps are completed, press"OK", the analyzer will start testing mode for 10 seconds.

The Bee alarm keeps emitting "Be"sounds when the testing mode is closed. Press any button to stop the "Be"sounds.

If the voltage of battery is too low. the "low"sign at the below left position on the screen will flash, please recharge the battery and test it again.

packing list

1 x Battery Tester

1 x Instruction Manual

Notice

1. Please allow 1‑2in error due to manual measurement. Thanks for your understanding.
2. Monitors are not calibrated same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard.