KLAJHJD Non vacuum Pneumatic Polishing Machine - 5 inch

Parameter Information: Air Inlet Size: 1/4 Inch No-load speed: 10000 rpm Average Air Consumption: 8 cfm Air Pressure: 90 Psi Product Description: Features: - the best hand stress on the tool is from 5kg to 7kg when operation. - Movement grinding speed, effectively shortening the operating time. - small volume,high speed, low noise. - Plastic Lightweight, high balance, the use of time does not produce fatigue ,high stability. - Cylinder after heat treatment, durable. - Trigger pressure speed control gear speed. - Air consumption is small, suitable for long working hours. - Use (applicable industry) Automotive, trains, ships, electric cars, furniture and so on. Model: Non vacuum Pneumatic Polishing Machine Applicable Sandpaper: 5 / 6inch Air Tube Inner Diameter: 6.25 (mm) Noise Value: 65DB Exhaust Direction: Rear exhaust Place of Application: Polishing Grinding Waxing Note: - Please the air supply when replacing the sand paper or the backing pad. - Wear protection glassess,eye protector,dust mask and gloves at operation. - Have a short break in every 30 minutes to avoid any possible injure due to tiredness. - Do not touch the rotating part of the tool with your hand or your body at operation. - Do not have rotating at high speed to avoid possible injure to human body and possible tool damage. - Start your sanding job after you fit the sanding pad flat on the surface you are working on. - Stop your job when finding any irreguar sound or vibration at operation and then check and repair the tool. - Because that you are using clean compressed air at operation.Use an air filter at the air installation to clean the dust out of the compressed air. - Drop some oil to the motor and then run the tool and then run the tool slowly for a minute and finally start your work auto lubricator/oiler is recomme