6COM SFP+ DAC Cable - 1 M (3.3ft)

Cost-Effective Fiber Alternative

SFP+ DAC (Direct Attach Copper) passive twinax cable is suitable for very short distances transmission and offers a highly cost-effective and low power solution to connect within racks and across adjacent racks. SFP+ directly attached Twinax cable assemblies support 10 Gigabit Ethernet, 10 Fibre Channel, and other industry standards. This copper cable provides a cost-effective alternative to purchasing expensive fiber optic transceivers and cables for distances up to 7 meters.

10G SFP+ DAC Twinax Cable for Cisco, Ubiquiti, D-Link, Supermicro, Netgear, Mikrotik, other Open Switches.

• Connector Type: SFP+ to SFP+
• Max Data Rate: 10Gbps
• Minimum Bend Radius: 23mm
• Wire AWG: 30AWG
• Cable Length: 1m (3.3ft)
• Jacket Material: PVC (OFNR)
• Temperature: 0 to 70°C (32 to 158°F)
• Protocols: 1x InfiniBand QDR, DDR, SDR, 10G Gigabit Ethernet, Fibre Channel

Install a 10G DAC Cable

A. Install SFP+ Modules

1. Remove the protective ESD cap from the connector.
2. Slide the SFP+ cable end into the slot until it locks into position(There is an audible click when the connector is properly seated.)

B. Remove SFP+ Modules

1. Pull on the SFP+ latch pull lanyard.
2. Grasp the SFP+ connector on both sides and remove it from the system.
3. If possible, replace the ESD protective cap or put the SFP+ into an ESD protected bag.

Safety Information

Notice

1. The cables can only be installed or replaced by qualified personnel.
2. Please wear antistatic gloves.
3. Caution against moisture.
4. Do not disassemble or modify the cables.

Warning

Don't approach or look the optical fiber exit with naked eyes directly. Excessive bending is strictly prohibited.